LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2015 >> Impala Limited LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Wheel Alignment System) >> Repair Instructions >> Rear Toe Adjustment
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Rear Toe Adjustment

WARNING: This page is about a different car, the 2015 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the alignment on an alignment rack. Wheel Alignment Measurement 
    Fig 1: Cam Bolt
    GM2018868Courtesy of GENERAL MOTORS COMPANY
  2. If adjustment is necessary, remove the rear suspension link inner nut and bolt. DISCARD the nut bolt.
  3. Rotate the rear suspension link inner bolt to adjust the toe angle. Wheel Alignment Specifications 
  4. Hand tighten the rear suspension link inner nut, but do not fully tighten.
    NOTE: Do not tighten the new fasteners yet in order to allow for movement.
  5. Re-inspect the rear toe angle and adjust as necessary.
  6. Hold the NEW rear suspension link inner bolt and tighten the NEW rear suspension link inner nut.
    CAUTION: Refer to Fastener Caution .

    Tighten 

    • First pass: 90 N.m (66 lb ft)
    • Final pass: plus 60 degrees
  7. Repeat the procedure for the opposite rear wheel.
scientia non olet · About LEMON Manuals