Installation Procedure

Install the battery tray (1) into position.

Fig 1: Battery Tray
Courtesy of GENERAL MOTORS COMPANY
Install the battery tray fasteners (1) and tighten to 22 N.m (16 lb ft).

Fig 2: Engine Control Module Bracket
Courtesy of GENERAL MOTORS COMPANY

CAUTION: Refer to Fastener Caution .
Attach the engine control module bracket (3) to the battery tray (2).
Attach the battery current sensor to the battery tray.
Attach the radiator surge tank clamp bracket. Refer to Radiator Surge Tank Clamp Bracket Replacement (Right Side) and Radiator Surge Tank Clamp Bracket Replacement (Left Side) .
Attach the battery positive cable retainer (1) to the battery tray.

Fig 3: Battery Positive Cable Retainer
Courtesy of GENERAL MOTORS COMPANY
Attach the battery positive cable retainers (1) to the battery tray and bracket.

Fig 4: Battery Positive Cable Retainers
Courtesy of GENERAL MOTORS COMPANY
Install the battery (1) into position on the battery tray.

Fig 5: Battery
Courtesy of GENERAL MOTORS COMPANY
Install the battery hold down retainer (2) and tighten the fastener (1) to 8 N.m (71 lb in).

Fig 6: Battery Hold Down Retainer Fastener
Courtesy of GENERAL MOTORS COMPANY
Install the battery positive cable to the battery post and tighten the clamp fastener (2) to 5 N.m (44 lb in).

Fig 7: Protective Cover
Courtesy of GENERAL MOTORS COMPANY
Install the protective cover (1) to the battery positive cable.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .