Circuit/System Verification
- Run the vehicle in propulsion system active mode for 1 minute, then vehicle OFF for 30 seconds.
- Verify DTC P16FF is not set.
- If the DTC is set
- Verify the K20 ECM has the latest calibration in Calibration Information.
- If the K20 ECM does not have the latest calibration, program the K20 ECM.
- If the K20 ECM has the latest calibration, replace the K20 ECM.
- Verify the DTC does not set.
- If the DTC is set, replace the K20 ECM.
- If the DTC does not set
- All OK.
- If the DTC is not set
- All OK.