Fastener Specifications (Diesel)
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Emission Reduction Fluid Injector Gasket |
| Exhaust Front Pipe Gasket |
| Exhaust Gas Recirculation Pipe Gasket |
| Exhaust Manifold Gasket |
| Nitrogen Oxides Catalytic Converter Gasket |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Catalytic Converter Clamp | 25 N.m (18 lb ft) |
| Exhaust Manifold Bolt | |
|
27 N.m (20 lb ft) |
|
27 N.m (20 lb ft) |
|
27 N.m (20 lb ft) |
| Transmission Mount Strut Bolt | |
|
100 N.m (74 lb ft) |
|
90 - 105 degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Catalytic Converter Brace Bracket Nut | 22 N.m (16 lb ft) |
| Catalytic Converter Brace Nut | 22 N.m (16 lb ft) |
| Catalytic Converter Heat Shield Bolt | 9 N.m (80 lb ft) |
| Emission Reduction Fluid Injector Nut | 9 N.m (80 lb ft) |
| Exhaust Brace Stud | 9 N.m (80 lb ft) |
| Exhaust Front Pipe Nut | 22 N.m (16 lb ft) |
| Exhaust Gas Recirculation Pipe Bolt | 10 N.m (89 lb in) |
| Exhaust Gas Recirculation Temperature Sensor | 45 N.m (33 lb ft) |
| Exhaust Muffler Hanger Bracket Nut | 22 N.m (16 lb ft) |
| Exhaust Muffler Insulator Nut | 22 N.m (16 lb ft) |
| Exhaust Muffler Nut | 22 N.m (16 lb ft) |
| Exhaust Muffler to Front Pipe Nut | 22 N.m (16 lb ft) |
| Exhaust Particulate Sensor | 45 N.m (33 lb ft) |
| Exhaust Pipe Clamp | 30 N.m (22 lb ft) |
| Exhaust Temperature Sensor | 45 N.m (33 lb ft) |
| Nitrogen Oxides Sensor | 50 N.m (37 lb ft) |
| Turbocharger Heat Shield Bolt | 9 N.m (80 lb in) |
| Turbocharger Heat Shield Nut | 9 N.m (80 lb in) |