Installation Procedure
- { If equipped } Install Steering Column Lock Control Module (2)
- { If equipped } Install Bolt (1) @Steering Column Lock Control Module and tighten 3.5 N.m (31 lb in)
- Install Steering Column (1)
- Hand-tight the NEW 4 steering column nuts (2).
- Tighten the steering column lower fasteners before you tighten the steering column upper fasteners. Failure to do this can damage the steering column.
- Tighten the steering column fasteners to the specified torque. Overtightening the upper steering column fasteners could affect the steering column collapse.
- Steering Column Nut - Tighten in the sequence shown. 22 N.m (16 lb ft)
- Connect the steering column electrical connectors.
- Connect the intermediate steering shaft to the steering column.
- Install Intermediate Steering Shaft Upper Bolt (1) and tighten
- First pass: 25 N.m (18 lb ft)
- Final pass: 180 - 195 degrees
- Install Floor Front Air Outlet Duct Replacement - Left Side
- Install Instrument Panel Lower Airbag Replacement - Driver Side
- Install Turn Signal Switch Bracket Replacement
- Steering Column Upper Trim Cover Replacement
- Install Instrument Panel Knee Bolster Replacement
- Power Steering Control Module Calibration
CAUTION:
Refer to Fastener Caution .
WARNING:
In order to ensure the intended function of the steering column in a vehicle during a crash and in order to avoid personal injury to the driver, perform the following:
CAUTION:
Refer to Fastener Caution .