LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2017 >> Express 2500 Base, Van Cargo Extended, 2.8L Eng VIN 1 >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    Fig 1: EBCM & BPMV
    GM2001464Courtesy of GENERAL MOTORS COMPANY
  1. Carefully align and install the EBCM (1) to the BPMV.

    Do not force the components together.

    2. CAUTION:

    Refer to Fastener Caution .

    Fig 2: EBCM Bolts
    GM2001462Courtesy of GENERAL MOTORS COMPANY
  2. Install new EBCM bolts (1).

    Tighten the bolts in a cross pattern to 3 N.m (27 lb in).

  3. Connect the electrical connector to the EBCM.
  4. Install the brake modulator shield and the mounting nuts, if equipped, and tighten to 25 N.m (18 lb ft).
  5. Install the brake modulator shield mounting bolt and tighten to 25 N.m (18 lb ft).
  6. Lower the vehicle.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery)Battery Negative Cable Disconnection and Connection (Dual Battery) .
  8. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals