Installation Procedure
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE:
Ensure the grease does not contaminate the following parts:
- wheel speed sensor bore holes
- bearing fastener threads
- wheel speed sensor
Grease the steering knuckle surface of the front wheel speed sensor (1).
- Grease the steering knuckle surface of the front wheel bearing/hub (2).
Position the front brake shield (2) and wheel bearing/hub assembly (1) in the steering knuckle.
- WARNING:
Refer to Torque-to-Yield Fastener Warning .
CAUTION:This is a self-retaining fastener joint that does not require thread locking compounds. Do not attempt to clean the threads with a standard tap. If a standard tap is used, damage to the joint threads will occur.
CAUTION:Refer to Fastener Caution .
Tighten the NEW bearing/hub bolts (1) a first pass to 90 N.m (66 lb ft).
- Tighten the NEW bearing/hub bolts (1) a final pass to an additional 60 - 75 degrees, using the EN-45059 meter.
Install the wheel speed sensor wiring harness to the steering knuckle.
- Install the wheel speed sensor (2).
- Install the wheel speed sensor bolt (1) and tighten to 6 N.m (53 lb in).
- Install the brake rotor. Refer to Front Brake Rotor Replacement .
- Install the NEW wheel drive shaft retaining nut and washer. Refer to Front Wheel Drive Shaft Replacement - Right Side , or Front Wheel Drive Shaft Replacement - Left Side .
- Remove the support and lower the vehicle.