Installation Procedure

Install the engine oil pressure sensor (2) to the engine and tighten to 35 N.m (26 lb ft).

Fig 1: Engine Oil Pressure Sensor Connector
Courtesy of GENERAL MOTORS COMPANY

CAUTION: Refer to Fastener Caution .
Connect the engine oil pressure sensor connector (1).
Install the transmission mount bracket bolt (1) and transmission mount bracket (2) and tighten to 22 N.m (16 lb ft).

Fig 2: Transmission Mount Bracket Bolt
Courtesy of GENERAL MOTORS COMPANY
Connect the 2 engine master harness wiring harness retainer (1) and evaporative emission canister purge solenoid valve hose.

Fig 3: Engine Master Harness Wiring Harness Retainers
Courtesy of GENERAL MOTORS COMPANY
Install the engine control module. Refer to Engine Control Module Replacement .