LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2017 >> Spark LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Power Steering System) >> Repair Instructions >> Steering Gear Boot Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2028058

    Install a new clamp (2) loosely on the inner part of the steering gear boot.

  2. Apply grease from the service kit to the indicated locations.
    3. NOTE:

    The steering gear boot must seat in the appropriate groove on the steering gear.

  3. Install the steering gear boot (1) over the steering linkage inner tie rod and onto the steering gear.
  4. GM2028057

    Adjust boot clamp (1) to marking on steering gear to keep correct installation position.

  5. Using CH-804  pliers crimp the inner steering gear boot clamp (1).
  6. GM2028056

    Install the steering gear outer boot clamp (2).

  7. Install the steering linkage inner tie rod nut (1).
  8. Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
scientia non olet · About LEMON Manuals