Inspection Procedure

Fig 1: Inspecting Capsules On Steering Column Bracket Assembly

Courtesy of GENERAL MOTORS COMPANY

Inspect the capsules on the steering column bracket assembly. Verify that the capsules are seated securely in the bracket slots and inspect the capsules for any loose conditions when pushed or pulled by hand. If the capsules are not secure, perform one of the following procedures:
- If the bracket is bolted to the jacket assembly, replace the bracket.
- If the bracket is welded to the jacket assembly, replace the jacket assembly.

Fig 2: Inspecting Jacket Assembly Dimensions

Courtesy of GENERAL MOTORS COMPANY

NOTE:

Measurement procedure only for manually adjusted steering columns.

Inspect the jacket assembly for collapse by measuring the distance from the lower edge of the upper jacket to a defined point on the lower jacket. If measured dimensions (A), are not within specifications (100 mm), install a steering column.