Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Accessory DC Power Control Module (3) - Install

CAUTION:

Accessory DC Power Control Module Bolt (2) - Install and tighten [2X] 9 N.m (80 lb in)
Accessory DC Power Control Module Nut (1) - Install and tighten [2X] 9 N.m (80 lb in)
Courtesy of GENERAL MOTORS COMPANY

High Voltage Electrical Connector (1) - Connect
Electrical Connector (2) - Connect
Install the retainers. (3)
Courtesy of GENERAL MOTORS COMPANY

Battery Positive Junction Block Cable (3) - Install
Battery Positive Junction Block Cable Bolt (1) - Install and tighten 22 N.m (16 lb ft)
Retainer (2) - Engage
Drive Motor Battery Impact Absorber (4) - Install
Courtesy of GENERAL MOTORS COMPANY

Drive Motor Generator Control Module Tray (2) - Install - Drive Motor Generator Control Module Tray Replacement
Enable the high voltage system. High Voltage Enabling