Installation Procedure

Remove the CH-6015 plugs from fuel feed tank pipe and fuel feed pipe.
Courtesy of GENERAL MOTORS COMPANY

Install the fuel feed pipe and secure with the rear fuel pipe clip.
Connect the fuel tank feed pipe connector (1) to the fuel feed pipe. Refer to Plastic Collar Quick Connect Fitting Service .
Courtesy of GENERAL MOTORS COMPANY

Close the 5 fuel pipe clips (1).
Courtesy of GENERAL MOTORS COMPANY

Install the EVAP canister cover (2) and tighten the EVAP canister cover fasteners (1) to 9 N.m (71 lb in).
Courtesy of GENERAL MOTORS COMPANY

Install the frame reinforcement (2) and tighten the frame reinforcement fasteners (1) to 60 N.m (44 lb ft).
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Connect the electrical wiring harness connector to the fuel pressure sensor (4).
Clip the fuel feed pipe (2) into the retainer clip (3).
Remove the CH-807 plugs from the fuel feed pipe connectors.
Connect the front fuel feed pipe connector (1) to the fuel injector rail and the fuel feed pipe (2). Refer to Plastic Collar Quick Connect Fitting Service .
Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .