Circuit/System Verification
- Ignition - On/Vehicle - In Service Mode
- S13D Door Lock Switch - Driver - Not Pressed
Verify the scan tool parameter: Driver Door Lock Switch = Inactive
- If not the specified state
Refer to: Circuit/System Testing - Test 1
- Go to next step: If the specified state
- If not the specified state
- Operate the component: S13D Door Lock Switch - Driver - Lock Switch & Unlock Switch
Verify the scan tool parameter: Driver Door Lock Switch = Lock & Unlock
- If not the specified state
Refer to: Circuit/System Testing - Test 2
- Go to next step: If the specified state
- If not the specified state
- S13P Door Lock Switch - Passenger - Not Pressed
Verify the scan tool parameter: Driver Door Lock Switch = Inactive
- If not the specified state
Refer to: Circuit/System Testing - Test 1
- Go to next step: If the specified state
- If not the specified state
- Operate the component: S13P Door Lock Switch - Passenger - Lock Switch & Unlock Switch
Verify the scan tool parameter: Driver Door Lock Switch = Lock & Unlock
- If not the specified state
Refer to: Circuit/System Testing - Test 2
- Go to next step: If the specified state
- If not the specified state
- Operate the component: S13D Door Lock Switch - Driver - Lock Switch & Unlock Switch
Verify the component works as specified:
- M14D Door Lock Actuator - Driver = Lock & Unlock
- M14LR Door Lock Actuator - Left Rear = Lock & Unlock
- M14P Door Lock Actuator - Passenger = Lock & Unlock
- M14RR Door Lock Actuator - Right Rear = Lock & Unlock
- {M14D Door Lock Actuator - Driver} If the component does not activate
Refer to: Circuit/System Testing - Test 3
- {M14LR Door Lock Actuator - Left Rear} If the component does not activate
Refer to: Circuit/System Testing - Test 4
- {M14P Door Lock Actuator - Passenger} If the component does not activate
Refer to: Circuit/System Testing - Test 4
- {M14RR Door Lock Actuator - Right Rear} If the component does not activate
Refer to: Circuit/System Testing - Test 4
- If none of the components operate
Refer to: Circuit/System Testing - Test 5
- Go to next step: If all functions work properly
- All OK.