Sunroof Module Assembly Replacement

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Sunroof Module Assembly

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the sunroof window. Refer to Sunroof Window Replacement . Remove the headliner. Refer to Headlining Trim Panel Replacement . Disconnect the sunroof harness electrical connectors. Disconnect the drain hoses from the sunroof frame. Do not remove the drain hoses from the vehicle, disconnect the drain hoses at all the corners of the sunroof frame spigot only. Refer to Sunroof Housing Front Drain Hose Replacement and Sunroof Housing Rear Drain Hose Replacement .
1	Sunroof Module Bolts (Qty :8) CAUTION: Refer to Fastener Caution . Procedure With an assistant, lower and remove the sunroof module assembly from the vehicle. Place the sunroof assembly on a clean dry surface. Transfer all necessary components to the new module assembly.
2	Sunroof Module Assembly Procedure Transfer all necessary components Adjust the sunroof window. Refer to Sunroof Window Height and Opening Fit Adjustment Verify the proper operation of the sunroof before securing the headliner. Ensure the motor/actuator initialization/teach process has been done. Refer to Sunroof Motor/Actuator Initialization/Teach Process . Water test vehicle before installing the trim to ensure No leaks.

Callout

Component Name

Preliminary Procedures

Remove the sunroof window. Refer to Sunroof Window Replacement .
Remove the headliner. Refer to Headlining Trim Panel Replacement .
Disconnect the sunroof harness electrical connectors.
Disconnect the drain hoses from the sunroof frame. Do not remove the drain hoses from the vehicle, disconnect the drain hoses at all the corners of the sunroof frame spigot only. Refer to Sunroof Housing Front Drain Hose Replacement and Sunroof Housing Rear Drain Hose Replacement .

Sunroof Module Bolts (Qty :8)

CAUTION: Refer to Fastener Caution .

Procedure

With an assistant, lower and remove the sunroof module assembly from the vehicle.
Place the sunroof assembly on a clean dry surface.
Transfer all necessary components to the new module assembly.

Sunroof Module Assembly

Procedure

Transfer all necessary components
Adjust the sunroof window. Refer to Sunroof Window Height and Opening Fit Adjustment
Verify the proper operation of the sunroof before securing the headliner.
Ensure the motor/actuator initialization/teach process has been done. Refer to Sunroof Motor/Actuator Initialization/Teach Process .
Water test vehicle before installing the trim to ensure No leaks.