LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2018 >> Spark LT, Standard Trans >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup - All Systems >> Repair Instructions >> K71 Transmission Control Module: Programming and Setup (MFQ) >> Programming an Existing Control Module
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Programming an Existing Control Module

To program an existing control module, perform the following procedure:

  1. Open the Service Programming System (SPS) - Refer to: Service Programming System (SPS) 
  2. Select: J2534 MDI
  3. Select: Reprogram ECU
  4. Select: Vehicle Data
  5. Select: K71 Transmission Control Module
    6. NOTE:

    The following procedure updates the control module software.

  6. Select: Programming
  7. Select: Normal
  8. Follow the on-screen instructions.
    9. NOTE:

    The following procedure configures the control module and carries out all necessary further steps for proper functioning of the control module.

  9. Select: Configuration & Setup
  10. Select: Normal
  11. Follow the on-screen instructions.
scientia non olet · About LEMON Manuals