Installation Procedure
- Position a NEW steering gear boot inner clamp on the steering gear boot.
- Apply a small amount of grease on the steering linkage inner tie rod and the steering gear housing where the steering gear boot sits.
Steering Gear Boot (1) - Install
Use the CH-22610 pliers to tighten the steering gear boot inner clamp (1).
Steering Gear Boot Outer Clamp (2) - Install
- Steering Linkage Inner Tie Rod Nut (1) - Install
- Steering Linkage Outer Tie Rod - Install - Steering Linkage Outer Tie Rod Replacement
- Measure and adjust the front toe. Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment