Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Liftgate Lower Trim Finish Panel Bolt (1) - Remove
With a flat bladed plastic trim tool, remove the liftgate trim finish panel pull cup (2).
Courtesy of GENERAL MOTORS COMPANY

With a flat bladed plastic trim tool, remove the liftgate upper center trim finish panel (1).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The luggage shade pivots are a one-time use component and will break upon removal.

Luggage Shade Pivot (1)-Both Sides - Remove and DISCARD [2x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Liftgate Upper Side Trim Finish Panel (1)-Both Sides - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Use a flat-bladed trim tool to aid in the removal of the liftgate lower trim finish panel from the liftgate.

Liftgate Lower Trim Finish Panel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using the appropriate tool, release the liftgate release switch retainers at each end and remove.
Disconnect the electrical connector.
Liftgate Release Switch (1) - Remove