Removal Procedure

Disable the SIR system. SIR Disabling and Enabling
Front Side Door Trim - Remove - Front Side Door Trim Removal and Installation
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Remove the 7 front side door front auxiliary weatherstrip retainers (1).
Front Side Door Front Auxiliary Weatherstrip (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Side Door Window Belt Reveal Molding Bolt (1) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Front Side Door Window Belt Reveal Molding (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Side Door Armrest Bracket Bolt (2) - Remove [2x]
Front Side Door Pull Handle Bracket (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Route front side door inside handle cable through hole in front side door water deflector (1) while removing it from the door.
Front Side Door Water Deflector (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connector.
Using an appropriate trim tool release the retainers securing the electrical connector (1).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Component made transparent for graphic clarity.

Pull the weatherstrip back to gain access to the front side door window frame rear applique bolts (1).
Front Side Door Window Frame Rear Applique Bolt (1) - Remove [2x]
Using the appropriate tool, release the front side door window frame rear applique (2) from the door panel.
Front Side Door Window Frame Rear Applique (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Do NOT use a heat gun to remove adhesive back components secured to plastic panels/appliques to prevent damage to the panel/applique when removing.

Near Field Communication Exterior Module (1) - Remove