Test 36D - Left Front Door Unlock Problem With Remote Keyless Entry (RKE)
NOTE:
For wiring diagram, refer to WIRING DIAGRAM
. Perform TEST VER-1
after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting any module connector.
- Gain access to the Remote Keyless Entry (RKE) module. See Figure . Disconnect RKE module Black connector. Go to next step.
- Using DRB in voltmeter mode, check voltage on RKE module Black connector terminal No. 8 (Pink wire). See Figure . If voltage is less than 10 volts, repair open Pink wire. If voltage is more than 10 volts, go to next step.
- Check voltage on RKE module Black connector terminal No. 1 (Pink/Violet wire). Depress left front door lock switch to UNLOCK position. If voltage is less than 10 volts, repair open Pink/Violet wire. If voltage is more than 10 volts, replace RKE module.