Manual Bleeding
- Fill master cylinder (if necessary). Reinstall master cylinder cap. Remove rubber caps from all 4 bleeder valves. Install clear hose on bleed valve at one wheel. Place other end of hose in clean transparent container of clean brake fluid. Ensure end of clear hose is submerged in brake fluid.
- Have an assistant pump brake pedal 3-4 times. Hold brake pedal down. Open bleed valve at least one full turn. Brake pedal should drop to floor. Close bleed valve. Release brake pedal. Repeat bleeding procedure until brake fluid flow is clear and free of bubbles. Proceed to next bleed screw of brake bleeding sequence. See BLEEDING SEQUENCE
table. Install rubber caps on all 4 bleeder valves and refill master cylinder.
BLEEDING SEQUENCE
| Application |
Sequence |
| All Models |
LR, RF, RR, LF |