LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Air Conditioning Controls) >> Mode Door Actuator >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Mode Door Actuator: Installation

WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the wire harness connector to the mode door actuator.
  2. Install the mode door actuator on the HVAC housing, making sure its keyed shaft is positioned properly.
  3. Install the three fastener screws and tighten to 2.2 N.m (20 in.lbs.).
  4. Reposition the center support bracket and install fastener. Refer to BODY for Electronic Control the procedures.
  5. Install the rear seat heat forward adaptor duct.
  6. Install the center floor heat adaptor duct.
  7. Install the floor console(Refer to INSTALLATION ).
  8. Install the left and right underpanel ducts.
  9. Connect the negative battery cable remote terminal to the remote battery post (Refer to INSTALLATION ).
scientia non olet · About LEMON Manuals