LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Air Conditioning Controls) >> Mode Door Actuator >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Mode Door Actuator: Installation

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the wire harness connector to the mode door actuator.
  2. Install the mode door actuator on the HVAC housing, making sure its keyed shaft is positioned properly.
  3. Install the three fastener screws and tighten to 2.2 N.m (20 in. lbs.).
  4. Reposition the center support bracket and install fastener.
  5. Install the rear seat heat forward adaptor duct.
  6. Install the center floor heat adaptor duct.
  7. Install the floor console (Refer to INTERIOR ).
  8. Install the left and right underpanel ducts.
  9. Connect the negative battery cable remote terminal to the remote battery post.
scientia non olet · About LEMON Manuals