A/C Heater Control: Installation
WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Place the control into place on the back of the instrument panel center bezel and install the six retaining screws to the A/C heater control.
- Connect the two electrical connectors to the back of the control head and traction control switch (if equipped). Install the instrument panel center bezel. Install the ash receiver assembly, if necessary.
- Connect the negative battery cable remote terminal to the remote battery post. To allow the BCM to learn the new control head, perform HVAC system calibration. See HVAC SYSTEM CALIBRATION under ADJUSTMENTS.