Spark Plug Tube: Installation
WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Apply Mopar® Stud and Bearing Mount to a new tube approximately 1 mm (0.039 in.) from the end of tube, in a 3 mm (0.118 in.) wide area.
- Install sealer end of tube into the cylinder head. Then carefully install the tube using a hardwood block and mallet. Install the tube until it is seated into the bottom of the bore.
- For spark plug tube seal replacement, (Refer to REMOVAL ).
- Install cylinder head cover(s). (Refer to INSTALLATION )