Disassembly - Lower Control Arm (Pivot Bushing)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, 2003 Chrysler 300M, and 2002 Dodge Intrepid. However, it is still accessible from the selected car via links, so may be relevant.

Remove lower control arm and tension strut as an assembly from the vehicle.
Separate the tension strut from the lower control arm assembly.
Position lower control arm in arbor press with large end of pivot bushing inside Receiver, Special Tool MB-990799, as shown (Fig 1). Position Remover, Special Tool 6644-2, on top of pivot bushing (Fig 1).
Using the arbor press, press the lower control arm pivot bushing out of lower control arm.
Remove the pressed out lower control arm pivot bushing from the Receiver and discard.

Fig 1: Removing Lower Control Arm Pivot Bushing
Courtesy of DAIMLERCHRYSLER CORP.