Washer Fluid Level Switch: Removal
WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
- Hoist vehicle.
- Remove front fascia as necessary (left side only and use a 2x4 to prop left edge of fascia away from body). Refer to FRONT FASCIA for removal procedures.
- Disconnect the wire connector from the reservoir fluid level sensor.
- Gently pry sensor away from reservoir and out of grommet. Care must be taken not to puncture reservoir (Figure ).
- Remover rubber grommet from reservoir and throw away.