LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Wiper System & Washer System) >> Wiper Linkage >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Wiper Linkage: Installation

WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Grommet eyelet may have been removed from rubber isolator on rear inboard and forward outboard mounting grommets during disassembly. Install if removed.
  1. Install "U" nut to body (if necessary).
  2. Install the module linkage mounting grommets.
    NOTE: When assembling master link or slave link to module frame, use channel locks wrapped in cloth to prevent damage to ball and socket joint. Apply light pressure to assemble socket to ball.
  3. Connect the wiper module master link to the pivot lever and motor crank by carefully snapping together. Do not damage ball and socket or seal.
  4. Connect wiper module slave link to pivot levers by carefully snapping together. Do not damage ball and socket or seal.
  5. Install the wiper module into the vehicle. Refer to WIPER MODULE  .
  6. Connect the negative battery cable remote terminal to the remote battery post.
scientia non olet · About LEMON Manuals