Cruise Control Servo: Service and Repair

REMOVAL
1. Remove the negative battery cable.
2. Disconnect the vacuum hose from servo.
3. Remove two nuts attaching speed control cable and mounting bracket to servo.
4. Remove servo from the mounting bracket.
5. Disconnect electrical connectors and vacuum hose.
6. Remove cable from throttle cam.
7. Remove clip attaching cable to servo.

INSTALLATION
1. Install servo cable through large hole in bracket, to servo and install clip.
2. Install speed control cable to throttle cam.
3. Connect electrical connector.
4. Insert servo studs through holes in speed control mounting bracket and cable.
5. Install nuts, tighten to 7 Nm (60 in. lbs.).
6. Connect the vacuum hose to servo.
7. Install the negative battery cable.