Power Window Switch: Service and Repair

Window Switch and Bezel Replacement

REMOVAL

Battery Negative Remote Cable Removal:

1. Disconnect and isolate the battery negative remote cable.

Window Switch Bezel:

2. Start at the rear center of the bezel. Using your fingers or a trim stick, lift the bezel upwards and slightly inboard to disconnect the two rear clips. Use care not to mar the door trim.
3. With the rear of the bezel raised, pull the forward end up to release the third clip.
4. Disconnect the power window switches and door lock switch wire connectors.
5. Remove attaching screws and remove window switch.

INSTALLATION
For installation, reverse the above procedures.