Removal & Installation

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: SKIM is located in steering column, by ignition switch. See Figure .

Disconnect negative battery cable. Remove knee bolster. Remove upper and lower steering column covers. Disengage steering column wire retainer from SKIM. Remove SKIM retaining screw. Disconnect SKIM connector. Slide SKIM from around ignition switch and remove SKIM. To install, reverse removal procedure.