Power Window Motor: Service and Repair

REMOVAL
1. Move the window to the full-up position, if possible.
2. Open hood.

Battery Negative Cable Remove/Install:

3. Disconnect and isolate the battery negative cable.
4. Remove door trim panel.
5. Disconnect electrical connector to window motor.
6. Remove window regulator.
7. With regulator on bench, remove three screws retaining the motor to the regulator and remove motor.

INSTALLATION
1. With regulator on bench, install three screws retaining the motor to the regulator.
2. Install the window regulator.
3. Connect electrical connector to window motor.
4. Install door trim panel.
5. Connect the battery negative cable.
6. Close hood
7. Verify vehicle and system operation.