LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Voyager Base, 3.3 G >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Body Control Modules) >> Programming >> Remote Keyless Entry Transmitter >> Without Scan Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Without Scan Tool

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2000 Plymouth Voyager, 2000 Plymouth Grand Voyager, 2000 Dodge Grand Caravan, 2000 Dodge Caravan, and 2000 Chrysler Voyager. However, it is still accessible from the selected car via links, so may be relevant.
  1. To use this method of programming, a previously programmed transmitter must be used. Ensure transmitter batteries have about 3.2 volts each. Turn ignition on. Place transmission in Park. If vehicle is equipped with anti-theft system, ensure system is in disarm mode.
  2. Using a previously programmed transmitter, press and hold unlock button 5-10 seconds. While still holding unlock button down, press panic button, then release both buttons. Chime should sound once to indicate Body Control Module (BCM) has grounded the RKE module program enable wire. Press any button on transmitter. Chime should sound once to indicate RKE module has accepted the signal.
  3. Repeat step 2)  for all transmitters that will be used by vehicle. Up to a total of 4 transmitters can be programmed. Programming mode will last for 30 seconds. To exit programming mode sooner, turn ignition off.
scientia non olet · About LEMON Manuals