LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2001 >> Voyager Base, 3.3 G >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Body Control Modules) >> Verification Tests >> Abs Verification Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Abs Verification Test

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2000 Plymouth Voyager, 2000 Plymouth Grand Voyager, 2000 Dodge Grand Caravan, 2000 Dodge Caravan, and 2000 Chrysler Voyager. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Ensure brake system is operating properly before test driving vehicle.
  1. Remove all test equipment and jumper wires. Connect any disconnected components. Connect scan tool to Data Link Connector (DLC). DLC is located under driver's side of instrument panel, right of steering column. Turn ignition on. Using scan tool, record and clear Diagnostic Trouble Codes (DTCs) from all modules. Turn ignition off. Wait 15 seconds. Turn ignition on. Wait one minute. Using scan tool, retrieve DTCs from all modules. If no DTCs exist, go to next step. If any DTCs exist, perform appropriate test. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table under SELF-DIAGNOSTIC SYSTEM.
  2. Test drive vehicle for at least 5 minutes and perform several anti-lock braking stops. Using scan tool, retrieve DTCs from all modules. If no DTCs exist, system is operating correctly and customer's complaint cannot be duplicated, repair is complete. If any DTCs exist, perform appropriate test. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table under SELF-DIAGNOSTIC SYSTEM.
scientia non olet · About LEMON Manuals