LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2002 >> Neon LE, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmissions >> Solenoid/Pressure Switch Assembly >> Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Solenoid/Pressure Switch Assembly: Installation

NOTE: If solenoid/pressure switch assembly is being replaced, it is necessary to perform the TCM Quick Learn Procedure. Refer to DIAGNOSIS - 41TE article.
  1. Install solenoid/pressure switch assembly and new gasket to transaxle. (Fig 1).
    Fig 1: Installing Solenoid/Pressure Switch Assembly & Gasket
    G01031274Courtesy of DAIMLERCHRYSLER CORP.
  2. Install and torque three (3) bolts (Figure) to 13 N.m (110 in. lbs.).
  3. Install input speed sensor (Figure) and torque to 27 N.m (20 ft. lbs.).
  4. Connect input speed sensor connector.
  5. Install solenoid/pressure switch 8-way connector and torque to 4 N.m (35 in. lbs.).
  6. Install air cleaner/throttle body assembly.
  7. Connect battery negative cable.
  8. If solenoid/pressure switch assembly was replaced, perform TCM Quick Learn procedure. Refer to DIAGNOSIS - 41TE article.
scientia non olet · About LEMON Manuals