Power Mirror Motor
- Remove front door trim panel to gain access to power mirror wire connector. See DOOR TRIM PANEL under REMOVAL & INSTALLATION.
- Disconnect wire harness connector to power mirror switch.
- Using two jumper wires:
- Connect one to a 12-volt source.
- Connect the other to a good body ground.
- See POWER MIRROR MOTOR TEST table for proper wire connections at the switch connector. See Figure .
POWER MIRROR MOTOR TESTMirror Operation Apply 12 Volts To Terminal No. Apply Ground To Terminal No. Driver's Side Up 2 6 Down 6 2 Left 6 1 Right 1 6 Passenger's Side Up 9 6 Down 6 9 Left 6 10 Right 10 6 - If results shown in table are not obtained, check for open or shorted circuit. Replace mirror assembly as necessary.