Power Window Motor: Service and Repair

REMOVAL
1. Move the window to the full UP position position, if possible
2. Disconnect and isolate the battery negative cable.
3. Remove door trim panel.
4. Disconnect electrical harness connector from motor.
5. Remove window regulator.
6. With regulator on bench, remove three screws retaining the motor to the regulator and remove motor.

INSTALLATION
1. With regulator on bench, install three screws retaining the motor to the regulator.
2. Install the window regulator.
3. Connect the electrical harness connector to window motor.
4. Install door trim panel.
5. Connect battery negative cable.