LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2003 >> Voyager Base, 2.4 B >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Power Liftgate System >> Latch >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Liftgate System: Latch: Installation

  1. Connect the liftgate lock cylinder link rod on the cinch latch assembly. Rotate the plastic retaining clip 90° to lock retaining clip on linkrod.
  2. Connect the link rod on the lock cylinder.
  3. Install three new power latch retaining bolts. Torque to 10 N.m (90 in. lbs.).
  4. Connect the power latch electrical connector and secure push pin retainers.
  5. Connect the negative battery cable.
  6. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes related to the power latch.
  7. Verify power liftgate system and power cinch / release latch operation. Cycle the power liftgate through one complete open and close cycle, this will allow the power liftgate control module to relearn its cycle with the new components.
  8. Verify power liftgate manual operation. Using liftgate key rotate the lock cylinder to verify door operation. Pull door open using exterior liftgate handle / switch.
  9. Install the liftgate trim panel. Refer to BODY for the procedure.
scientia non olet · About LEMON Manuals