LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2004 >> Crossfire Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> Ignition System >> Knock Sensor >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Knock Sensor: Installation

  1. Position the knock sensors (1) on the engine block.
    2. NOTE: The knock sensor bolt torque is higher than other sensors. If the proper torque is not applied to the knock sensor, driveability can be affected.
  2. Install the retaining bolts. Tighten the bolts to 20 N.m (15 ft. lbs.).
  3. Connect the wire harness connectors.
  4. Install the intake manifold. See 3.2L V6 article.
scientia non olet · About LEMON Manuals