LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2004 >> Crossfire Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> Tune-Up >> Ignition System >> Knock Sensor >> Installation
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Knock Sensor: Installation

  1. Position the knock sensors (1) on the engine block.
    2. NOTE: The knock sensor bolt torque is higher than other sensors. If the proper torque is not applied to the knock sensor, driveability can be affected.
  2. Install the retaining bolts. Tighten the bolts to 20 N.m (15 ft. lbs.).
  3. Connect the wire harness connectors.
  4. Install the intake manifold. See 3.2L V6 article.
scientia non olet · About LEMON Manuals