Section 130 (Speed Control): Switch: Removal

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Depending on engine control computer (JTEC having a 3-plug connector or 5.7L V-8 NGC having a 4-plug connector), 2 types of switches are used. Both types of switches are internally and externally different. The switches used with the NGC system have attached pigtail leads ( Figure ). The switch used with the JTEC system does not have an attached pigtail lead.

Remove switch mounting screw (Fig 1). or (Figure)
Pull switch from steering wheel.
Unplug electrical connector from switch (Fig 1), or, switch pigtail wire harness from steering wheel wire harness (Figure) and remove switch.

Fig 1: Identifying Electrical Connector
Courtesy of DAIMLERCHRYSLER CORP.