3.7L/4.7L Gas
WARNING: This page is about a different car, the 2005 Dodge Pickup and 2005 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - THROTTLE CABLE PIN |
| 2 - THROTTLE BODY BELLCRANK |
| 3 - PUSH UP HERE |
- Disconnect negative battery cable at battery.
- Remove air intake tube at top of throttle body.
The accelerator cable must be partially removed to gain access to speed control cable.
- Hold throttle in wide open position. While held in this position, slide throttle cable pin (1). See Fig 1 from throttle body bellcrank.
1 - THROTTLE CABLE 2 - RELEASE TAB 3 - PICK OR SCREWDRIVER 4 - PLASTIC CABLE MOUNT - Using a pick or small screwdriver (3), press release tab (2). See Fig 2 to release plastic cable mount (4) from bracket. Press on tab only enough to release cable from bracket. If tab is pressed too much, it will be broken.
Slide plastic mount (4). See Fig 2 towards right side of vehicle to remove throttle cable from throttle body bracket.
Courtesy of DAIMLERCHRYSLER CORP.
1 - THROTTLE BODY BELLCRANK 2 - SPEED CONTROL CABLE CONNECTOR - Using finger pressure only, disconnect servo cable connector (2). See Fig 3 at throttle body bellcrank pin by pushing connector off bellcrank pin towards front of vehicle. DO NOT try to pull connector off perpendicular to the bellcrank pin. Connector will be broken.
Courtesy of DAIMLERCHRYSLER CORP.
1 - THROTTLE CABLE BRACKET 2 - PLASTIC CABLE MOUNT 3 - SPEED CONTROL CABLE - Slide speed control cable plastic mount (2) towards right of vehicle to remove cable (3) from throttle body bracket (1). See Fig 4.
- Remove servo cable from servo. Refer to Removal/Installation in SERVO .