LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (5.7L Engine (Service Information)) >> Intake Manifold >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Intake Manifold: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Position intake manifold.
  2. Install intake manifold retaining bolts, and tighten in sequence from the middle bolts towards the outside in a crisscross pattern. Torque fasteners to 12 N.m (105 in. lbs.).
  3. Install EGR tube.
  4. Install wire harness on intake manifold.
  5. Connect electrical connectors for the following components:
    • Manifold Absolute Pressure (MAP) Sensor
    • Fuel Injectors
    • ETC ( Electronic Throttle Control )
  6. Install ignition wires.
  7. Connect Brake booster hose, purge hose, and MUA hose ( Make Up Air hose ).
  8. Install air inlet hose.
  9. Connect negative cable to battery.
  10. Install engine cover.
scientia non olet · About LEMON Manuals