Headlamp Control Module: Service and Repair

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Disconnect the one electrical connector to the HID translator module (1).
3. Remove the one nut (2) holding the module (1) to the bracket.

INSTALLATION

WARNING: WHEN REPLACING THE HEADLAMP LEVELING MODULE/HID TRANSLATOR MODULE, THE SYSTEM MUST BE CALIBRATED USING A SCAN TOOL.




1. Install the one nut (2) holding the module (1) to the bracket.
2. Connect the one electrical connector to the HID translator module.
3. Connect the battery negative cable.
4. Using a Scan Tool, calibrate the headlamp levelling system.