Front Suspension: Knuckle: Installation

Fig 1: Locating Upper Ball Joint Stud Nut At Upper Control Arm

Courtesy of DAIMLERCHRYSLER CORP.

Install the steering knuckle and nut (1) to the upper ball joint stud. Tighten to 45 N.m (33 ft. lbs.).

Fig 2: Locating Ball Joint Stud Nut At Steering Knuckle
Courtesy of DAIMLERCHRYSLER CORP.
Install the steering knuckle and nut to the lower ball joint stud (1). Tighten to 105 N.m (77 ft. lbs.).

Fig 3: Locating Tie Rod Joint Stud Nut At Steering Knuckle
Courtesy of DAIMLERCHRYSLER CORP.
Install the tie rod end and nut onto the steering knuckle. Tighten to 50 N.m (37 ft. lbs.).

Fig 4: Locating Wheel Speed Sensor & Bolt
Courtesy of DAIMLERCHRYSLER CORP.
Install the Wheel Speed Sensor (WSS) and bolt. Tighten to 22 N.m (16 ft. lbs.).

Fig 5: Identifying Disc Brake Dust Shield Hex Bolts
Courtesy of DAIMLERCHRYSLER CORP.
Install the disc brake dust shield and three hex bolts (1). Tighten to 22 N.m (16 ft. lbs.).

Fig 6: Identifying Disc Brake Rotor
Courtesy of DAIMLERCHRYSLER CORP.
Install the front wheel hub. (Refer to SUSPENSION/FRONT/HUB/BEARING - INSTALLATION) .
Install the front disc brake rotor (1). (Refer to BRAKES/HYDRAULIC/MECHANICAL/ROTORS - INSTALLATION) .

Fig 7: Removing/Installing Front Disc Brake Caliper
Courtesy of DAIMLERCHRYSLER CORP.
Install the front disc brake caliper (1). (Refer to BRAKES/HYDRAULIC/MECHANICAL/DISC BRAKE CALIPERS - INSTALLATION) .
Install the front wheel and tire assembly. (Refer to TIRES/WHEELS - STANDARD PROCEDURE) .
Lower the vehicle and check vehicle alignment. (Refer to SUSPENSION/WHEEL ALIGNMENT - SPECIFICATIONS) .