LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2005 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Fuel System) >> Fuel Injection >> Idle Air Control Motor >> Installation >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Idle Air Control Motor: Installation: Notes

WARNING: This page is about a different car, the 2005 Dodge SX, 2005 Dodge SRT-4, and 2005 Dodge Neon. However, it is still accessible from the selected car via links, so may be relevant.

When servicing throttle body components, always reassemble components with new O-rings and seals where applicable. Never use lubricants on O-rings or seals, damage may result. If assembly of component is difficult, use water to aid assembly. Use care when removing hoses to prevent damage to hose or hose nipple.

  1. The new idle air control motor has a new O-ring installed on it. If pintle measures more than 1 inch (25 mm) it must be retracted. Use the DRB III® Idle Air Control Motor Open/Close Test to retract the pintle (battery must be connected.)
  2. Carefully place idle air control motor into throttle body.
  3. Install mounting screws. Tighten screws to 4.5 N.m (40 in. lbs.) torque.
  4. Connect electrical connector to idle air control motor
  5. Connect negative cable to battery.
scientia non olet · About LEMON Manuals