Installation - Upstream 1/1
WARNING: This page is about a different car, the 2005 Dodge SX, 2005 Dodge SRT-4, and 2005 Dodge Neon. However, it is still accessible from the selected car via links, so may be relevant.
New sensors have compound on the threads and do not require an additional coating.
- Install sensor using an oxygen sensor crow foot wrench such as Snap-On tool YA8875 or equivalent. See Figure. Tighten the sensor to 28 N.m (20 ft. lbs.) torque.
- Plug sensor connector.
- Lower vehicle.