LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2005 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Fuel System) >> Fuel Injection >> Throttle Control Cable >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Throttle Control Cable: Installation

WARNING: This page is about a different car, the 2005 Dodge SX, 2005 Dodge SRT-4, and 2005 Dodge Neon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install grommet into dashpanel.
  2. From the engine compartment, push the housing end fitting into the dashpanel grommet.
  3. From the engine compartment, rotate the throttle lever forward to the wide open position and install cable clasp. See Figure.
  4. Install cable housing (throttle body end) into the cable mounting bracket on the engine.
  5. Install throttle cable cover.
  6. From inside the vehicle, hold up pedal and feed throttle cable core wire through hole in upper end of the pedal shaft. Install cable retainer. See Figure .
  7. Install cable retainer clip. See Figure.
  8. Install grommet into dashpanel.
  9. From the engine compartment, push the housing end fitting into the dashpanel grommet.
  10. From the engine compartment, rotate the throttle lever forward to the wide open position and install cable clasp. See Figure.
  11. Install cable housing (throttle body end) into the cable mounting bracket on the engine.
  12. From inside the vehicle, hold up pedal and feed throttle cable core wire through hole in upper end of the pedal shaft. Install cable retainer. See Figure.
  13. Install cable retainer clip. See Figure.
  14. Install the hose from the turbo to air cleaner box at the turbo and tighten clamp.
  15. Install the air cleaner box and install the hose from the turbo to air cleaner box and tighten clamp.
  16. Connect the negative battery cable.
scientia non olet · About LEMON Manuals