LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2006 >> Sebring GTC >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Restraints System (Service Information)) >> Occupant Restraint Controller >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Occupant Restraint Controller: Removal

WARNING: This page is about a different car, the 2006 Dodge Viper. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open deck lid.
  2. Remove four bolts to battery compartment cover and remove cover.
  3. Disconnect and isolate the battery negative cable.
  4. Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or instrument panel component service.
  5. Remove six Allen screws to shifter bezel.
  6. Remove shifter shaft with knob and body.
  7. Remove floor console bezel and parking brake body.
  8. Remove eight screws and disconnect one electrical connector to center console and remove console from vehicle.
  9. Remove six screws and disconnect one electrical connector to instrument panel center bezel and remove bezel from vehicle.
  10. Using a trim stick (special tool #C-4755) or equivalent, gently pry out on cluster bezel.
  11. Disconnect one electrical connector and remove bezel from instrument panel.
  12. Remove radio and electrical connections.
  13. Remove two electrical connectors to Occupant Restraint Controller (ORC).
  14. From inside center stack area, remove four retaining bolts to ORC and remove from floor tunnel.
scientia non olet · About LEMON Manuals