LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2006 >> Sebring GTC >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (HVAC Systems) >> Controls >> A/C Pressure Transducer >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

A/C Pressure Transducer: Installation

WARNING: This page is about a different car, the 2006 Dodge Viper. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use only the specified O-ring as it is made of special material for R-134a. Use only refrigerant oil of the type required for the A/C compressor.
  1. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the A/C pressure transducer fitting.
  2. Install the A/C pressure transducer onto the discharge line. Tighten the A/C pressure transducer securely.
  3. Connect the wire harness connector to the A/C pressure transducer.
  4. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals