Knock Sensor: Removal

WARNING: This page is about a different car, the 2006 Chrysler Crossfire. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting/Connecting Wire Harness Connectors At Knock Sensors

Courtesy of DAIMLERCHRYSLER CORP.

Remove the intake manifold from the engine. (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - REMOVAL) - except SRT or (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - REMOVAL) - SRT .
Disconnect the wire harness connectors at the knock sensors (1).
Remove the retaining bolts.
Remove the knock sensors from the engine block.